Complete Overhaul (Turbo)

  1. Remove seat post from bicycle
  2. To change cable/housing refer to directions above.
  3. Remove bottom cap nut (item #68) seat post (Warning: Seat post has a spring inside and is under pressure, keep face away and remove cap slowly) Also, Do not remove pin (#288 while the inside tube is removed (#22) unless the spring has been removed in
  4. Clean dirt and re-assemble. Refer to schematic as needed. (Shim kits & replacement parts are available from manufacturer.)
  5. If pin (item #88) is removed and cleaned, use SMALL amount of lube before replacing.
  6. Re-assemble and install on bike

If you have any additional questions call Customer Service at 406.883.3555
or email us at
[email protected]